Ryobi A25RT02 User Manual download pdf (Page 15)

Inch

ASSEMBLY

Inch

FEED

DIRECTION

STARTING

PIN HOLES

STARTING PIN

INSTALL

REMOVE

Fig. 16

SLOT

FEATHERBOARD

BOLT

CARRIAGE

BOLT

WASHER

FENCE LOCK KNOB

FEED

DIRECTION

Inch

Fig. 17

MITER GAUGE

SLOT

MITER

GAUGE BAR

POINTER

FEATHERBOARD

Fig. 15

 Unplug the router table and/or the router.

 Select the throat plate you wish to use.

 Press throat plate into insert plate slot until it snaps into

place.

 To remove, push throat plate out from the bottom of the

insert plate.

ATTACHING THE FEATHERBOARD

See Figure 15.

 Unplug the router table and/or the router.

 Insert the featherboard bolts through the slots in the fence

assembly.

 Slide the featherboard over the featherboard bolts.

 Install the fence lock knobs and carriage bolt washers

over the carriage bolts.

 Tighten the fence lock knobs.

INSERTING THE STARTING PIN

See Figure 16.

Place the starting pin on the router table and use it as a pivot

point when cutting small, odd-shaped pieces.

NOTE: It is not necessary to use the fence when you are

using the starting pin, but the bit guard should be used to

cover the cutter. Additionally, only use piloted cutters when

using the starting pin.

 Unplug the router table and/or the router.

 Place the starting pin into the hole to the right of the router

table throat opening.

 Push the pin in to secure.

INSTALLING THE MITER GAUGE

See Figure 17.

 Unplug the router table and/or the router.

 With the router table right side up, and the front edge

closest to you, place the miter gauge bar in the slot near

the front of the table with the pointer on the right.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Ryobi A25RT02 User Manual Page 15

Comments to this Manuals

Related products and manuals for Routers Ryobi A25RT02