Ryobi A25RT02 User Manual download pdf (Page 14)

MAKING INSERT PLATE LEVEL

See Figure 12.

 Unplug the router table and/or the router.

 Check to see if the insert plate mounted assembly is level

with a straight edge or level.

 Loosen insert plate screws.

 Using the supplied hex key, tighten or loosen the adjust-

ing screws depending on how the insert plate needs to be

adjusted in order to make the insert plate level.

 Tighten insert plate screws with a screwdriver.

ATTACHING THE FENCE ASSEMBLY

See Figure 13.

 Unplug the router table and/or the router.

 Place the router table right side up with the back edge

closest to you.

 Slide the carriage bolt washers onto the carriage bolts.

 Slide carriage bolts through the slot in the router table

and through the slots in the fence assembly.

 Slide the fence lock knob washer over the carriage

bolts.

 Install the fence lock knobs over the carriage bolts.

 Tighten the fence lock knobs.

ASSEMBLY

Inch

FEED

DIRECTION

Fig. 12

INSERT

PLATE

STRAIGHT

EDGE

ADJUSTING

SCREWS

HEX KEY

INSERTING AND REMOVING THROAT

PLATES

See Figure 14.

The throat plate provides a stable surface around the cutter

and prevents objects from falling through the throat plate

and damaging the spindle.

The proper size throat plate depends on the size and shape

of the cutter. When inserted, the throat plate opening should

be within approximately 1/4 in. of the outermost edge of

the cutter.

Fig. 14

Inch

FEED

DIRECTION

THROAT PLATE

NOTCH

TAB

Inch

FENCE

LOCK KNOBS

CARRIAGE BOLTS

FENCE LOCK

KNOB WASHER

SLOT

Fig. 13

CARRIAGE BOLT

WASHER

FENCE

ASSEMBLY

WARNING:

Make sure throat plates snap securely into place. Do

not use if snaps are damaged or throat plates do not

snap in securely. Failure to do so could result in serious

personal injury.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Ryobi A25RT02 User Manual Page 14

Comments to this Manuals

Related products and manuals for Routers Ryobi A25RT02