Ryobi TS1343L Operator's Manual download pdf (Page 14)

ASSEMBLY

Fig. 8

Fig. 10

LOOSEN

MITER

LOCK HANDLE

TIGHTEN

DUST

BAG

EXHAUST

PORT

BASE

WORK

CLAMP

MITER LOCK HANDLE

See Figure 8.

To install the miter lock handle, place the threaded stud on

the end of the miter lock handle into the threaded hole in

the control arm. Turn clockwise to tighten.

DUST BAG

See Figure 9.

A dust bag is provided for use on the miter saw. It fits over

the exhaust port on the upper blade guard. To install it,

remove dust guide from exhaust port. Then, squeeze the

two metal clips to open the mouth of the bag and slide it

on the exhaust port. Release the clips. The metal ring in

the bag should lock in between the grooves on the exhaust

port. To remove the dust bag for emptying, simply reverse

the above procedure.

WORK CLAMP

See Figure 10.

The work clamp provides greater control by clamping the

workpiece to the fence or the miter table. It also prevents

the workpiece from creeping toward the saw blade. This is

very helpful when cutting compound miters.

Depending on the cutting operation and the size of the

workpiece, it may be necessary to use a C-clamp instead

of the work clamp to secure the workpiece prior to making

the cut.

WARNING:

In some operations, the work clamp assembly may

interfere with the operation of the blade guard assembly.

Always make sure there is no interference with the blade

guard prior to beginning any cutting operation to reduce

the risk of serious personal injury.

To install the work clamp:

Place the shaft of the work clamp in either hole on the

miter table base.

 Rotate the knob on the work clamp to move it in or out

as needed.

Fig. 9

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Comments to this Manuals

No comments

Ryobi TS1343L Operator's Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools Ryobi TS1343L