Ryobi HP214 User Manual download pdf (Page 14)

OPERATION

Fig. 10

REMOVING BITS

See Figure 9.

 Lock the switch trigger by placing the direction of rotation

selector in the center position.

 Rotate the chuck sleeve clockwise to open the chuck

jaws.

NOTE: Rotate the chuck body in the direction of the arrow

marked UNLOCK to loosen the chuck jaws. Do not use

a wrench to tighten or loosen the chuck jaws.

 Remove the drill bit.

INSTALLING/REMOVING THE MAGNETIC BIT

HOLDER

See Figure 11.

 Lock the switch trigger by placing the direction of rotation

selector in the center position.

 Open or close the chuck jaws to a point where the opening

is slightly larger than the end of the magnetic bit holder.

Also, raise the front of the drill slightly to keep the bit

holder from falling out of the chuck jaws.

 Insert the bit holder.

NOTE: Open the chuck jaws just enough to fully insert

the end of the magnetic bit holder. The body of the bit

holder should rest against the chuck jaws when the jaws

are closed and tightened.

 Tighten the chuck jaws on the bit holder.

 Insert a bit into the open end of the magnetic bit

holder.

 To remove the magnetic bit holder, see Removing

Bits.

WRONG

Fig. 11

MAGNETIC BIT

HOLDER

UNLOCK

(RELEASE)

LOCK

(TIGHTEN)

CHUCK BODY

CHUCK

JAWS

BIT

1 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Ryobi HP214 User Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools Ryobi HP214