Ryobi CSB130JS Operator's Manual download pdf (Page 14)

Page 14

51.5

OPERATION

LENGTH OF CUT SCALE

Fig. 20

BEVEL

ADJUSTMENT

KNOB

ADJUSTMENT

SCREW

POSITIVE 0˚

BEVEL STOP

HEX NUT

COMBINATION

SQUARE

SAW BLADE

Fig. 21

POSITIVE 0° BEVEL STOP

See Figure 20.

Your saw has a positive 0° bevel stop that has been factory

adjusted to assure 0° angle of your saw blade, when making

90° cuts. However, misalignment can occur during shipping.

TO CHECK:

■ Unplug your saw.

WARNING:

Failure to unplug your saw could result in accidental start-

ing causing possible serious personal injury.

■ Place your saw in an upside down position on workbench.

See Figure 20.

■ Using a combination square, check squareness of saw

blade to the base of your saw.

TO ADJUST:

■ Unplug your saw.

WARNING:

Failure to unplug your saw could result in accidental start-

ing causing possible serious personal injury.

■ Lock bevel adjustment knob.

■ Loosen hex nut securing adjustment screw.

■ Turn screw and adjust base until square with saw blade.

■ Tighten hex nut and bevel adjustment knob securely.

WARNING:

Attempting to make cuts without bevel adjustment knob

securely tightened can result in serious injury.

LENGTH OF CUT SCALE

See Figure 21.

A length of cut scale has been provided on the base of your

saw. It is parrallel with the saw blade and can be used to

measure the distance into material the blade has cut.

NOTE: Six inches is the maximum length of the cut that can

be measured. Also, it is accurate only when the depth of cut

is set at full maximum depth.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Ryobi CSB130JS Operator's Manual Page 14

Comments to this Manuals

Related products and manuals for Circular saws Ryobi CSB130JS