Ryobi CSB130JS Operator's Manual download pdf (Page 10)

Page 10

WRONG

DEPTH OF CUT ADJUSTMENT

Always keep correct blade depth setting. The correct blade

depth setting for all cuts should not exceed 1/4 in. below the

material to be cut. More blade depth will increase the chance

of kickback and cause the cut to be rough.

TO ADJUST BLADE DEPTH

■ Unplug your saw.

WARNING:

Failure to unplug your saw could result in accidental starting

causing possible serious personal injury.

■ Loosen depth adjustment knob.

See Figure 9.

■ Hold base flat against the work and raise or lower saw

until the required depth is reached.

■ Tighten depth adjustment knob securely.

STARTING A CUT

KNOW THE RIGHT WAY TO USE YOUR SAW.

See Figure 11.

NEVER USE YOUR SAW AS SHOWN IN FIGURE 10.

NEVER PLACE YOUR HAND ON THE WORKPIECE

BEHIND YOUR SAW WHILE MAKING A CUT.

WARNING:

To make sawing easier and safer, always maintain proper

control of your saw. Loss of control of your saw could cause

an accident resulting in possible serious injury.

TO HELP MAINTAIN CONTROL:

■ Always support your work near the cut.

■ Support your work so the cut will be on your right.

■ Clamp your work so it will not move during the cut.

Place your work with its good side down.

NOTE: The good side is the side on which appearance is

important.

Before beginning a cut, draw a guide line along the desired

line of cut. Then place the front edge of the base on that part

of your work that is solidly supported.

See Figure 11.

OPERATION

Fig. 9

Fig. 10

Fig. 11

DEPTH

ADJUSTMENT

SCALE

DEPTH ADJUSTMENT KNOB

RIGHT

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comments to this Manuals

No comments

Ryobi CSB130JS Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Circular saws Ryobi CSB130JS