Ryobi DBJ50 Operations Instructions download pdf (Page 134)

Page 125 Power Equipment Usage Manual (Rev. 5/10)

“ref” edges. Also, check it with the bottom of one female finger. If edge is not square, the fence locks

are not holding.

After cutting this pattern on all work pieces, use second side of setup jig to set cutter to do the other

end. Raise or lower cutter to fit perfectly into the setup jig. Use uncut end of chip breaker. Put the wood

in the jig, referenced properly, and cut the second (uncut) end with fingers. Check the fit between the

two pieces. See that the finger fits are right, lining up perfectly on the “ref” faces. Now make all your

other boards and you are finished.

30.3.8. Finishing Up

To finish up, return “setup jig” to hanging near the blowpipe, raise spindle up and engage the orange

spindle lock handle to lock the spindle. Use the crescent wrench to remove the top nut by turning it

clockwise. Next, remove the lower nut by turning it counter clockwise. Remove cutter and put away,

replace all spacers and nuts (finger tight) and cleanup. Remove sled and put in tool room on the floor.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139

No comments

Ryobi DBJ50 Operations Instructions Page 134