Ryobi DBJ50 Operations Instructions download pdf (Page 105)

Page 96 Power Equipment Usage Manual (Rev. 5/10)

19.2.3. Assembling the Motor in the Router Base

CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

a. Loosen the clamp screw (A) Figure 1 to allow the power unit to be set in the base unit.

b. Insert motor unit into base aligning lower pin (B) with groove in base.

c. Rotate motor unit CLOCKWISE into base until upper guide pins are rigidly set in the groove of

the base.

d. Tighten clamp screw firmly.

19.2.4. Adjusting Depth of Cut

CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

a. Loosen clamp screw (A), Figure 3.

b. While holding base (E), turn motor unit (F), Figure

3, COUNTERCLOCKWISE until the tip of the bit is

above bottom surface of base.

c. Set router on flat wood surface.

d. Turn motor unit (F), Figure 3, CLOCKWISE until bit

touches the wood surface.

e. Tighten clamp screw (A), Figure 3.

f. Rotate depth adjusting ring (B), Figure 3, until the zero-line (C) is opposite the index line (D) on

the housing.

g. Loosen clamp screw (A), Figure 3.

h. Tip the router so bit is clear of the wood

surface. Turn motor unit (F), Figure 3

CLOCKWISE until the index line (D) on the

motor housing reaches the desired depth

indicated on the ring.

i. Tighten clamp screw (A), Figure 3 firmly.

NOTE: Setting the index line to 1/4" on the ring means

the cutting edge of the bit is exposed 1/4" below the

base.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 138 139

No comments

Ryobi DBJ50 Operations Instructions Page 105