Ryobi 767rj Operator's Manual

TrimmerPlus®725rE2-Cycle Gas Trimmer / Edger OPERATOR’S MANUALFOR QUESTIONS, CALL 1-800-345-8746 in U.S. or 1-800-265-6778 in CANADAwww.ryobi.comIMPOR

OIL AND FUEL INFORMATION10WARNING: Gasoline is extremely flammable. Ignited Vapors may explode.Always stop the engine and allow it to coolbefore filli

11STARTING/STOPPING INSTRUCTIONS4. Place the choke lever in the FULL choke position (A)(Fig. 5).8. If the engine does not start, repeat steps 4 throug

OPERATING INSTRUCTIONS122. While firmly holding the add-on, push it straight intothe Click-Link® coupler (Fig. 8).NOTE: Aligning the release button wi

13OPERATING INSTRUCTIONSFig. 10Fig. 11Each time the head is bumped, about 1 inch (25.4 mm.)of trimming line is released. A blade in the cuttingattachm

OPERATING INSTRUCTIONS14DECORATIVE TRIMMINGDecorative trimming is accomplished by removing allvegetation around trees, posts, fences, etc.Rotate the w

15OPERATING INSTRUCTIONSFREQUENCY MAINTENANCE REQUIRED REFER TO:Before Starting Engine Fill fuel tank with correct oil and fuel mixture. Page 10Every

16MAINTENANCE AND REPAIR INSTRUCTIONSLine Locking HoleTrimming LineLine Loading HoleEyelet5. Insert the line into the locking hole (Fig. 18). Do notpu

17MAINTENANCE AND REPAIR INSTRUCTIONSBump KnobFoam SealSpringInner ReelInstalling a Prewound Inner reel1. Turn the Bump Knob counterclockwise and remo

18MAINTENANCE AND REPAIR INSTRUCTIONS2. Pull out the bump knob, spring, and foam seal (Fig. 22).3. Pull the inner reel with existing line from the out

3. Install the new blade, blade retainer, and nut (Fig. 29). EDGER BLADE REPLACEMENTWARNING:To avoid serious personal injury,always wear gloves while

INTRODUCTION TABLE OF CONTENTS2THANK YOUThank you for buying this quality product. This modernoutdoor power tool will provide many hours of usefulserv

MAINTENANCE AND REPAIR INSTRUCTIONS20Fig. 32Fig. 33Fig. 344. Apply enough clean SAE 30 oil to lightly coat the filter (Fig. 34).Air Filter3. Wash the

6. Replace the air filter in the air filter/muffler cover (Fig. 32).NOTE: Operating the unit without the air filter and air filter/muffler cover assem

MAINTENANCE AND REPAIR INSTRUCTIONS22REPLACING THE SPARK PLUGUse a Champion RDJ7Y spark plug (or equivalent). The correct air gap is 0.020 inch (0.5 m

CLEANING AND STORAGE23TRANSPORTING• Allow the engine to cool before transporting. • Secure the unit while transporting.• Drain fuel from unit.• Tighte

TROUBLESHOOTING24CAUSE ACTIONCutting attachment bound with grass Stop the engine and clean cutting attachmentCutting attachment out of line Refill wit

SPECIFICATIONS25Engine Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

NOTES26

27The California Air Resources Board and RyobiOutdoor Products (ROP), are pleased to explain theemission control system warranty on your 1995 andlater

ALL IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE TWO (2) YEAR WARRANTY PERIOD OR NINETY (90) DAYS FOR PRODUCTSUSED FOR ANY COMMERCIAL PURPOSE. AC

CALIFORNIA EMISSION REGULATIONS3SPARK ARRESTORWARNING!RULES FOR SAFE OPERATIONNOTE: For users on U.S. Forest Land and in the states of California, Mai

RULES FOR SAFE OPERATION4READ ALL INSTRUCTIONS BEFORE OPERATING• Read the instructions carefully. Be familiar with thecontrols and proper use of the u

RULES FOR SAFE OPERATION5• Do not touch the engine or muffler. These parts getextremely hot from operation. When turned off theyremain hot for a short

SAFETY AND INTERNATIONAL SYMBOLSThis operator's manual describes safety and international symbols and pictographs that may appear on this product

SYMBOL MEANING• HOT SURFACE WARNINGDo not touch a hot muffler or cylinder. You may get burned. These parts get extremely hot from operation. When turn

RULES FOR SAFE OPERATION8KNOW YOUR UNITAPPLICATIONSAs a trimmer;• Cutting grass and light weeds.• Decorative trimming around trees, fences, etc.With E

ASSEMBLY INSTRUCTIONS97. Tighten the clamp screws evenly, until the J-handleis secure.6. While holding the unit in the operating position (Fig. 3), po