Ryobi BT3000 Operator's Manual download pdf (Page 7)

Page 7

ROUTER MOUNTING (Cont'd)

TO ASSEMBLE TABLE CLAMPING BRACKET

(Cont'd)

1. Remove end cap from rear rail as shown in figure 8.

2. Slide one of the special 5/16 in. T-nuts into channel of

rear rail.

3. Orient table clamping bracket as shown and secure

with a 5/16 in. washer and 5/16-18 x 3/4 in. knob bolt.

Note: Table clamping bracket fits in bottom slot of rear

rail. The slotted top of this bracket wraps around the

raised portion on the underside of the accessory table,

clamping it tightly against the rear rail.

4. Tighten knob bolt securely.

5. Reassemble end cap to rear rail.

FINAL ASSEMBLY

See Figure 9.

After all router mounting parts have been assembled, your

set-up should be similar to the illustration shown in figure 9.

1. Compare your set-up to the set-up shown in figure 9 and

make any necessary adjustments.

2. Recheck all knob bolts, loose parts, etc. and securely

tighten if necessary.

PREPARING FOR OPERATION

See Figure 9.

1. Adjust dust cover so that it will not come in contact with

workpiece during cutting operation.

2. Direction of feed of workpiece is from right to left as

shown by the arrow in figure 9.

3. Direction of feed must always be so that the workpiece

is being thrust against the sharp edges of rotating bit.

4. Workpiece must always be tight against guide fence.

Infeed fence should be adjusted to support uncut

workpiece while the outfeed fence should be adjusted

properly to support the workpiece after the cut passes

the router bit.

Fig. 9

Fig. 8

TABLE CLAMPING BRACKET

SHOWN COMPLETELY ASSEMBLED

ACCESSORY TABLE

TABLE

CLAMPING BRACKET

T-NUT

REAR RAIL

5/16 in. WASHER

KNOB BOLT

END CAP

ROUTER KIT SHOWN COMPLETELY ASSEMBLED

DIRECTION OF FEED IS FROM RIGHT TO LEFT

AGAINST SHARP EDGES OF ROTATING BIT

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Ryobi BT3000 Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Circular saws Ryobi BT3000