Ryobi BT3000 Operator's Manual download pdf (Page 4)

Page 4

ASSEMBLY

Read these instructions completely before beginning assembly of this kit.

WARNING:

The saw's motor cord must be disconnected from the

receptacle provided on the saw when using this kit with

a Router or Jig Saw mounted to the accessory table.

The power supply cord of the Router or Jig Saw must be

plugged into the receptacle and the saw's master switch

must be used to turn the Router or Jig Saw "ON" or

"OFF".

IMPORTANT

This router kit has been specifically designed for use with the

Ryobi Model RE600 Electronic Router Only. The hole

pattern on the mounting plate has not been drilled to

accommodate other routers on the market. Special mounting

screws are provided with the RE600 to insure safe, secure

mounting.

TO INSTALL T-NUTS FOR GUIDE FENCE

BRACKETS

See Figure 2.

This kit requires that five of the special 5/16 in. T-nuts

provided fit in the top channel of the rip fence on your BT3000

table saw. The first T-nut is required between the two

adjustment screws on top of the rip fence.

TO INSTALL:

1. Place rip fence against saw blade as shown in figure 2

and lock in place. This will insure that rip fence remains

square.

2. Using the appropriate allen wrench supplied with your

BT3000 table saw, loosen and remove rear adjustment

screw and washer on top of rip fence.

3. Slide one of the special 5/16 in. T-nuts into top channel

of rip fence and place it between two adjustment

screws. Note: T-nuts install from rear of rip fence.

4. Replace adjustment screw and washer.

5. Tighten adjustment screw securely.

6. Check rip fence for squareness with saw blade.

TO INSTALL REMAINING T-NUTS

See Figure 3.

1. For ease of assembly, unlock rip fence and slide away

from saw blade.

See Figure 3.

2. Lock rip fence.

3. Slide four remaining 5/16 in. T-nuts in top channel of rip

fence as shown in figure 3.

Note: You should now have five T-nuts in the top

channel of rip fence. Only one should be between

adjustment screws.

Fig. 2

Fig. 3

ROUTER MOUNTING

T-NUT SHOWN BETWEEN ADJUSTMENT SCREWS

ADJUSTMENT

SCREW

T-NUT

WASHER

RIP FENCE SHOWN

LOCKED AGAINST SAW BLADE

INSTALL T-NUTS FROM REAR OF RIP FENCE

T-NUT

1 2 3 4 5 ... 14

Comments to this Manuals

No comments

Ryobi BT3000 Operator's Manual Page 4

Comments to this Manuals

Related products and manuals for Circular saws Ryobi BT3000