Ryobi TS1141 User Manual download pdf (Page 15)

WARNING:

Assemble the saw head to the base before attempting to

use the product. Using the saw head without first install-

ing it to the base may result in serious personal injury.

ASSEMBLING THE MITER SAW HEAD TO THE

BASE

See Figures 10 - 11.

NOTE: If the miter saw you purchased is already factory

assembled, proceed to the next section to install the Dust

Bag. To determine if your saw was factory assembled, see

UNPACKING.

 Secure the base to the stand or other firm supporting

surface such as a workbench.

 Remove the paper seal from the miter saw head.

 Remove the tape securing the bolt from the back of the

saw head. Set the bolt, spring washer, and flat washer

aside.

 Place the miter saw head on the saw base oriented verti-

cally as shown in figure 10. Install the bolt, spring washer,

and flat washer; finger tighten.

 Using the blade wrench provided or a standard 5 mm hex

wrench, tighten the bolt. The bolt should be tightened

enough so that the saw head can be set to a 30º bevel

without allowing the saw head to drop under its own

weight.

 Install the bevel knob with flat washer and tighten until

the head is secure but not locked in position.

 Place the head at 0º. Install the bevel indicator so that the

indicator points to 0º. Tighten the bevel indicator screw

securely using the other end of the blade wrench or a

standard Phillips screwdriver.

NOTE: Check the saw head’s bevel position at both 0º

and 45º to make sure the indicator is correctly installed.

If the saw head cannot move to the 45º position, slightly

loosen the bolt at the back of the saw head.

ASSEMBLY

Fig. 11

Fig. 10

paper

seaL

tape

boLt

Miter saw

head

saw base

beveL

knob

beveL

indicator

screw

beveL

indicator

boLt

spring

washer

fLat

washer

fLat

washer

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Ryobi TS1141 User Manual Page 15

Comments to this Manuals

Related products and manuals for Power saws Ryobi TS1141