Ryobi TS1141 User Manual download pdf (Page 18)

note: before use,

repLace screw and

tighten secureLY

to prevent guard

MoveMent

ASSEMBLY

TO INSTALL/REPLACE THE BLADE

See Figures 16 - 17.

WARNING:

A 7-1/4 in. blade is the maximum blade capacity of the

saw. Never use a blade that is too thick to allow outer

blade washer to engage with the flats on the spindle.

Larger blades will come in contact with the blade guards,

while thicker blades will prevent the blade bolt from se-

curing the blade on the spindle. Either of these situations

could result in a serious accident and can cause serious

personal injury.

 Unplug the saw.

 Raise the saw arm.

 Rotate lower blade guard up and remove blade bolt cover

screw. Rotate blade bolt cover up and back to expose

the blade bolt.

 Depress the spindle lock button and rotate the blade bolt

until the spindle locks.

 Using the wrench provided, loosen and remove the blade

bolt.

NOTE: The blade bolt has left hand threads. Turn blade

bolt clockwise to loosen.

 Remove outer blade washer. Do not remove inner blade

washer.

 Wipe a drop of oil onto inner blade washer and outer

blade washer where they contact the blade.

WARNING:

If inner blade washer has been removed, replace it before

placing blade on spindle. Failure to do so could cause an

accident since blade will not tighten properly.

 Fit saw blade inside lower blade guard and onto spindle.

The blade teeth point downward at the front of saw as

shown in figure 17.

 Replace outer blade washer. Double “D” flats on blade

washers align with flats on spindle.

 Depress spindle lock button and replace blade bolt.

NOTE: The blade bolt has left hand threads. Turn blade bolt

counterclockwise to tighten.

CAUTION:

Always install the blade with the blade teeth and the

arrow printed on the side of the blade pointing down at

the front of the saw. The direction of blade rotation is also

stamped with an arrow on the upper blade guard.

 Tighten blade bolt securely.

 Replace the lower blade guard and blade bolt cover.

 Replace blade bolt cover screw and tighten securely.

Fig. 17

Lower

bLade

guard

bLade

outer bLade

washer with

doubLe “d” fLats

bLade

boLt

tighten

Loosen

bLade boLt

cover

screw

fLat(s)

on spindLe

bLade

boLt

cover

spindLe Lock

button

Fig. 16

inner bLade

washer with

doubLe “d” fLats

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

Ryobi TS1141 User Manual Page 18

Comments to this Manuals

Related products and manuals for Power saws Ryobi TS1141