Ryobi DBJ50 Operations Instructions download pdf (Page 61)

Page 52 Power Equipment Usage Manual (Rev. 5/10)

h. As the workpiece passes across the machine, move to the other side and complete the cut by

pulling the workpiece past the saw blade. Support the upper piece to keep it from pinching the

blade or the kerf protector, or falling away from the machine.

NOTE: When doing rip cuts, one gets the most accurate cut if 1/8” shims are inserted along

the way – to keep the top part of the wood from binding the blade.

i. Once the cut is complete, turn off the motor and wait for the blade to come to a full stop.

Remove the workpieces from the machine.

j. Rotate the turntable back to the vertical position and return the carriage to the top of the

guides. Lock the carriage in this position.

k. When making cuts that are less than 1”, the chatter guard (located inside the blade guard) must

be resting on the workpiece, not on the cut-off piece. (see Figure 2). If it is not positioned this

way, it will jam the workpiece and prevent the carriage from continuing through the cut. If the

saw jams, turn the tool OFF and wait for the blade to stop. Then back the saw out of the cut.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 138 139

No comments

Ryobi DBJ50 Operations Instructions Page 61