Ryobi DBJ50 Operations Instructions download pdf (Page 117)

Page 108 Power Equipment Usage Manual (Rev. 5/10)

22. SANDER, 6” BELT/12” DISK (Powermatic Model BD31A)

22.1. Safety Precautions

a. MAINTAIN at least 3” between fingers and the abrasive belt.

b. ALWAYS sand on the downward side of the disc so that the work is

held securely on the table.

c. MAKE SURE belt is tracking correctly.

d. MAKE SURE the belt or disc abrasive surface is not torn or loose.

e. KEEP the table free of objects which might “walk off’ during

operation.

f. NEVER WEAR gloves or hold work with a rag when sanding.

g. DO NOT SAND very small or very thin workpieces that cannot be

safely controlled. Loss of control of the workpiece can result in

injury.

h. SUPPORT workpiece adequately during operation. Maintain

control of work at all times.

i. ALWAYS use a backstop when using belt finishing machine in a horizontal position.

j. SHUT OFF machine and do not leave until it has come to a complete stop.

k. NEVER TURN THE MACHINE “ON” with the workpiece contacting the abrasive surface. Kickback

can occur.

l. AVOID AWKWARD OPERATIONS AND HAND POSITIONS. A sudden slip could cause a hand to

move into the abrasive disc or belt.

m. PROPERLY SUPPORT LONG OR WIDE WORKPIECES. Loss of control of the workpiece is

dangerous.

n. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORK on the table/work area when the

machine is running. A sudden slip could cause a hand to move into the abrasive surface. Severe

injury can result.

22.2. Setup & Use – Belt/Disk Sander

The sanders are setup by the Maintenance Team. There is no setup for the general user.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 138 139

No comments

Ryobi DBJ50 Operations Instructions Page 117