Ryobi RAP200G User Manual download pdf (Page 9)

9 — English

OPERATION

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection marked to comply with ANSI

Z87.1. Failure to do so could result in objects being thrown

into your eyes resulting in possible serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product. The

use of attachments or accessories not recommended

can result in serious personal injury.

ACCESSORIES

All accessories used with this product must be rated greater

than 3000 psi. Ensure compatibility and fit before using any

accessory with this product.

WARNING:

Risk of fire or explosion - spray area must be well

ventilated and away from spark of flames. Failure to heed

this warning could result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

Exterior painting and staining of decks, outdoor furniture,

fences, and interior/exterior rolling of walls.

WARNING:

To reduce the risk of injection NEVER change spray tip

without locking the lock-out thumbscrew on the sprayer

and NEVER point sprayer at any part of the body,

persons, or unit itself. In case of skin injection, seek

medical attention immediately. Failure to heed this may

cause serious personal injury.

LOCKING THE PISTOL-GRIP SPRAYER

See Figure 9, page 17.

Always lock the pistol-grip sprayer trigger when you have

stopped spraying to prevent the sprayer from being bumped

or triggered accidentally and causing injection.

Turn lock-off thumbscrew counterclockwise to lock

sprayer trigger.

Turn lock-off thumbscrew clockwise to unlock sprayer

trigger.

RELEASE PRESSURE PROCEDURE

Always follow this procedure when shutting paint station

OFF for any reason. This procedure releases pressure in the

high pressure hose.

 On pistol-grip sprayer, turn lock-off thumbscrew coun-

terclockwise to lock sprayer trigger.

Turn ON/OFF switch OFF.

 Turn prime/spray lever to PRIME, as shown in figure 10.

This releases pump pressure.

 Unlock sprayer trigger and point to inside wall of paint

container releasing unused paint or stain back into con-

tainer. This releases pressure in the hose and pistol-grip

sprayer.

Turn lock-off thumbscrew counterclockwise to lock

sprayer trigger.

 Leave prime/spray lever in the PRIME position until ready

to spray again.

FLUSHING THE PAINT STATION

Before using your new paint station or before beginning a

new project or changing colors, it is important to thoroughly

flush the paint station of any storage fluid, previous cleaning

fluid, or material left in the system. Follow instructions for

Cleaning the Paint Station before beginning any project.

SET UP AND PRIMING

See Figure 10-12, pages 17-18.

User must prime the pump and sprayer before beginning

any spraying or rolling.

The paint sprayer is designed to hold different container

sizes. You may use a 5 gallon, 2 gallon, 1 gallon, or 1 gallon

square container.

Fill paint container with desired paint or stain. Place lid on

container.

 Remove nozzle tip guard and spray tip from pistol-grip

sprayer.

Place intake tube in paint container.

Set return tube over waste container to flush out waste

material.

 Turn prime/spray lever to PRIME.

 Turn HIGH/LOW pressure control to LOW pressure.

Plug in the paint station.

Press and release the Manual Valve Release button to

make sure the check valve is clear.

 Turn ON/OFF switch ON.

 When material begins to flow through return tube set

return tube into paint container and clip to intake tube.

 Point pistol-grip sprayer (without guard and spray tip in

place) into waste container.

 Turn prime/spray lever to SPRAY.

 Unlock sprayer trigger.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

Dfi G586IPV Manual de usuario (48 paginas)

Marca: Dfi | Categoria: Motherboards | Tamaño: 0.54 MB |

Tabla de contenidos

G586IPV/E

FCC Statement on Class B

Table of Contents

Features and Specifications

Chapter 1

Introduction

Package Checklist

Chapter 2

Hardware Installation

Board Layout

System Memory

Installing a SIM Module

CPU Installation

Cache Memory

Installing Upgrade CPUs

Built-in Ports

Floppy Disk Drive Controller

Parallel Port

IDE Hard Disk Interface

Installing Expansion Cards

Software Installation

Award CMOS Setup Utility

Chapter 3

Standard CMOS Setup

Drive A and Drive B

BIOS Features Setup

Virus Warning

Quick Power On Self Test

Swap Floppy Drive

Boot Up Floppy Seek

Boot Sequence

Boot Up NumLock Status

Security Option

PCI/VGA Palette Snoop

OS Select for DRAM > 64MB

Video BIOS Shadow

Chipset Features Setup

Auto Configuration

Power Management Setup

Power Management

ISA Bus Clock

PM Control by APM

Video Off Method

Doze Mode

Standby Mode

Suspend Mode

HDD Power Down

Down & Resume Events)

PNP/PCI Configuration

Resources Controlled By

PCI IRQ Active By

PCI IDE IRQ Map To

Load BIOS Defaults

Load Setup Defaults

Integrated Peripherals

PCI Slot IDE 2nd Channel

Onboard Parallel Port

Onboard Parallel Mode

Onboard FDD Controller

Supervisor Password

User Password

Hard Drive Mode

Normal Mode

IDE HDD Auto Detection

Large Mode

HDD Low Level Format

Save & Exit Setup

Exit Without Saving

System Error Report

IDE Device Drivers

Appendix A

Types of Modules

Memory Address Map

Appendix B

Memory and I/O Maps

I/O Address Map

Appendix C

Connectors

Más productos y manuales para Placas base DFI

Modelos	Tipo de documento
P5BV3+/e	Manual de usuario DFI P5BV3+/e User`s manual [en] , 59 paginas
G7B330-B	Manual de usuario DFI G7B330-B User`s manual, 128 paginas
G5M300-P	Manual de usuario DFI G5M300-P User`s manual, 113 paginas
CA63-EN	Manual de usuario DFI CA63-EN User`s manual, 74 paginas
CD905-B Series	Manual de usuario DFI CD905-B Series User`s manual, 63 paginas
Q7-951	Manual de usuario DFI Q7-951 User`s manual [en] , 46 paginas
LanParty NFII Ultra B	Manual de usuario DFI LanParty NFII Ultra B User`s manual, 120 paginas
CA63-SN	Manual de usuario DFI CA63-SN User`s manual, 76 paginas
P5BV3+/e	Manual de usuario ISDN4LINUX - FAQ (deutsche Version) Uebersetzer: Wolfgang, 112 paginas
NB78-BL	Manual de usuario DFI NB78-BL User`s manual, 85 paginas
CL630-CRM	Manual de usuario DFI CL630-CRM User`s manual, 172 paginas
CR900-B	Manual de usuario DFI CR900-B User`s manual, 73 paginas
G586SP AIO	Manual de usuario DFI G586SP AIO User`s manual, 75 paginas
G5C900-B	Manual de usuario DFI G5C900-B User`s manual, 118 paginas
BL631-D	Manual de usuario DFI BL631-D User`s manual, 122 paginas
G586OPC	Manual de usuario DFI G586OPC User`s manual [en] [es] , 100 paginas
LR101 SERIES	Manual de usuario Hybrid Multi-Monitor Solutions Target Embedded, 3 paginas
G586IPC	Manual de usuario DFI G586IPC User`s manual, 67 paginas
LR102 SERIES	Manual de usuario DFI LR102 SERIES User`s manual, 138 paginas
G586VPA	Manual de usuario DFI G586VPA User`s manual, 81 paginas

Ryobi RAP200G User Manual Page 9

Comments to this Manuals

DFI G586IPV manuales

Dfi G586IPV Manual de usuario (48 paginas)

Tabla de contenidos

Más productos y manuales para Placas base DFI

Ryobi RAP200G User Manual Page 9

Comments to this Manuals

Related products and manuals for Tools Ryobi RAP200G

DFI G586IPV manuales

Dfi G586IPV Manual de usuario (48 paginas)

Tabla de contenidos

Más productos y manuales para Placas base DFI