Ryobi P301 Operator's Manual download pdf (Page 12)

OPERATION

Fig. 7

SETTING DEPTH

See Figure 6.

The depth adjustment knob increases or decreases the force

with which a staple is driven into the workpiece.

 Rotate the depth adjustment knob clockwise to increase

the force.

 Rotate depth adjustment knob counterclockwise to

decrease the force.

 Test on a scrap piece of the same material you are using

to achieve the desired depth.

NOTE: Harder materials will require more force to drive

a staple.

STAPLING

See Figure 7.

 Hold handle firmly with magazine flat to workpiece,

forming a 90º angle.

 Press the activation foot of the stapler down against the

workpiece. The activation foot must be depressed before

the switch trigger is depressed.

NOTE: The tool will drive another staple each time the

trigger is depressed as long as the activation foot is

depressed.

REMOVING A JAMMED STAPLE

 Remove battery pack from the tool.

 Hold tool upside down; squeeze latch and slide base

open.

 Remove unused staples from magazine.

 Remove jammed staple with needle nose pliers.

NOTE: You must remove jammed staple before using tool

any further. If you try to drive a staple while the tool is

jammed, you could cause damage to the mechanism.

Fig. 6

INCREASE

FORCE

DECREASE

FORCE

DEPTH

ADJUSTMENT

KNOB

1 ... 11 12 13 14

No comments

Ryobi P301 Operator's Manual Page 12