Ryobi P301 Operator's Manual download pdf (Page 11)

LATCH

OPERATION

Fig. 3

BATTERY

PACK

LATCHES

DEPRESS LATCHES TO

RELEASE BATTERY PACK

Fig. 4

STAPLES

Fig. 5

NOTE: This situation only occurs when continuous use of the

tool causes the batteries to become hot. It does not occur

under normal circumstances. Refer to CHARGING A COOL

BATTERY PACK for normal recharging of batteries. If the

charger does not charge your battery pack under normal

circumstances, return both the battery pack and charger

to your nearest Authorized Service Center for electrical

check.

TO INSTALL BATTERY PACK

See Figure 3.

� Place battery pack in your tool. Align raised rib on battery

pack with groove inside tool.

� Make sure the latches on each side of the battery pack

snap in place and battery pack is secured in tool before

beginning operation.

CAUTION:

When placing battery pack in the tool, be sure raised

rib on battery pack aligns with the bottom of the tool

and latches into place properly. Improper installation

of the battery pack can cause damage to internal

components.

TO REMOVE BATTERY PACK

See Figure 3.

 Locate latches on side of battery pack and depress to

release battery pack from the tool.

 Remove battery pack from the tool.

WARNING:

Battery tools are always in operating condition. Therefore,

switch should always be locked when not in use or

carrying at your side.

LOADING THE TOOL WITH STAPLES

See Figures 4 - 5.

 Remove battery pack from the tool.

 Hold tool upside down; squeeze latch and slide base

open.

 Place staples in channel, legs facing upward and close

base.

 Make sure the latch is securely locked in place.

 Reattach battery pack to tool.

1 ... 10 11 12 13 14

Comments to this Manuals

No comments

Ryobi P301 Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Staple guns Ryobi P301