Ryobi RT501W User Manual download pdf (Page 24)

ACCESSORIES

Fig. 35

Fig. 34

Using featherboards

See Figure 35

The featherboards provide support for the workpiece by

holding it securely, which helps minimize chatter and

kickback.

Insert the 2 featherboards as shown below, with the sli-

ding blocks positioned in the slot of the fence and then

securely tighten the knobs.

Insert the third featherboard in the slot of miter chanel and

tighten knob.

Using miter guide

See Figure 34

The miter guide can serve as extra support for routing

small workpieces and for ends of long workpieces.

NOTE: Make sure that the fence and miter bar slot are

parallel before cutting.

To cut miters, unclamp knob that secures the protractor

head. Turn head up to 60° in either direction. Retighten

knob.

When making cuts using the miter guide, hold the work-

piece firmly against the fence, the miter guide, and the

table.

WARNING:

Do not allow any body part to be in line with the router

bit at any time when the miter gauge is in use. Doing

so could lead to serious personal injury.

SECURING THE ROUTER TABLE

WARNING:

DO NOT use the router table unless it is firmly

mounted to a stable work surface. Failure to securely

mount the router table could lead to serious personal

injury and/or property damage.

See Figure 36

1. Secure router table to the work surface using wood

screws or sheet metal screws and washers (not

provided) through the holes in the legs or use a one

hand bar clamp to clamp the leg to the work surface.

Fig. 36

Bdal 6146.461 3Sprachen 04.06.2005 11:58 Uhr Seite 24

1 ... 23 24 25 26 27 28

No comments

Ryobi RT501W User Manual Page 24