Ryobi HP24 Owner's Manual download pdf (Page 18)

MAINTENANCE FOLLOWING USE

The following maintenance should be performed following each use.

Blade-Shaft Bearings

Remove sheet metal cover over blade shaft

and grease zerk fittings on base mount bear-

ings. Use premium wheel bearing grease to

lubricate all blade-shaft bearings.

Shaft bearings

Cross-adjustment rail system

Cross-Adjustment Rail System

No grease or applied lubrication is required for the

stainless steel screw feed and cross-adjustment

rail system. The slab saw cutting oil splash will

adequately lubricate the vice screw-feed, rails and

clutch parts. If the

carriage becomes hard to slide over the rails, clean

the rails with a rag and apply a liberal amount of

wheel bearing grease to the surface of the steel

rails to facilitate travel of the carriage over the rails.

HP18 & HP24 MAINTENANCE

WARNING

Place the ON/OFF switch in the OFF position and unplug cord prior to servicing

and when changing accessories, such as blades, belts, and the like.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

No comments

Ryobi HP24 Owner's Manual Page 18