Ryobi HP24 Owner's Manual download pdf (Page 10)

CARRIAGE FEED ENGAGE/DISENGAGEMENT

Lever operated clutch system using silicon bronze shoe with block (adjustable set screws).

INDEXING OR ROCK CUT WIDTH CONTROL

Crank handle operated stainless steel screw system.

TANK & HOOD COVER CONSTRUCTION

11 gauge steel box-construction 12 gauge hood with acrylic plastic viewing window.

TANK LEGS

11 gauge steel construction with locking casters on HP18 and HP24 saws.

OIL SLUDGE DRAIN

2” drain cap on HP18 and HP24 saws. Drain placement is on bottom of saw tank.

ON/OFF AUTOMATIC POWER CONTROL

HP18 and HP24 saws have adjustable chain for automatic shut-off control of power on/off switch.

DEPTH OF CUT

24” blade: 10 inches,

20” blade: 8 inches

18” blade: 7.5 inches

MATERIAL TYPES

Barranca Diamond Highland Precision Slab Saws can cut a variety of material types including lapidary

rock, natural and artificial glass, and gemstone minerals.

NOTE: Highland Precision Slab Saws are not designed to cut wood, ice, synthetics, graphite carbon,

plastics, or ferrous metal materials.

UNPACKING & ASSEMBLY

Your Highland Precision Slab Saw has been shipped from the factory thoroughly inspected and tested.

The blade has been factory installed and arbor nut securely tightened. No assembly is required. Do

not over-tighten the arbor nut prior to use.

Remove the saw from the pallet by unbolting legs from crate pallet and place it on a flat surface using

a forklift. Install casters on legs – one at a time - on HP18 and HP24 saws prior to operation.

HP18 & HP24 SPECIFICATION

SHAFT BEARINGS

Sealed flange mount ball bearings with zerk fittings for grease lubrication.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Ryobi HP24 Owner's Manual Page 10