Ryobi P504 User Manual download pdf (Page 8)

8 - English

WARNING:

If inner blade washer has been removed, replace it before

placing blade on spindle. Failure to do so could cause an

accident since blade will not tighten properly.

 Fit the saw blade inside the lower blade guard and onto

the spindle.

NOTE: The saw teeth point upward at the front of the

saw.

 Replace the outer blade washer.

 Depress the spindle lock button, then replace the blade

screw. Tighten the blade screw securely by turning it

counterclockwise.

 Return the blade wrench to the storage area.

NOTE: Never use a blade that is too thick to allow the outer

blade washer to engage with the flats on the spindle.

REMOVING THE BLADE

See Figure 3, page 14.

 Remove the battery pack from the saw.

Remove the blade wrench from the storage area.

Position the saw as shown, depress the spindle lock but-

ton, and remove the blade screw by turning it clockwise.

Remove the outer blade washer.

Remove the blade.

ATTACHING THE BLADE

See Figure 2, page 14.

WARNING:

A 5-1/2 in. blade is the maximum blade capacity of the

saw. Never use a blade that is too thick to allow outer

blade washer to engage with the flats on the spindle.

Larger blades will come in contact with the blade guard,

while thicker blades will prevent blade screw from secur-

ing blade on spindle. Either of these situations could

result in a serious accident.

 Remove the battery pack from the saw.

Remove the blade wrench (5 mm hex key) from the stor-

age area.

Depress the spindle lock button and remove the blade

screw and outer blade washer.

NOTE: Turn the blade screw clockwise to remove.

NOTICE:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

NOTE: Do not run the circular saw with spindle lock engaged.

Wipe a drop of oil onto the inner blade washer and outer

blade washer where they contact the blade.

ASSEMBLY

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other construction

activities may contain chemicals, including lead, known to the State of California to cause cancer, birth de-

fects, or other reproductive harm. Wash hands after handling.

Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products, and

• arsenic and chromium from chemically-treated lumber.

Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To

reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust

masks that are specially designed to filter out microscopic particles.

California Proposition 65

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments

Ryobi P504 User Manual Page 8

Comments to this Manuals

Related products and manuals for Power saws Ryobi P504