Ryobi C358 User Manual download pdf (Page 11)

Page 11

ADJUSTMENTS

Fig. 6

ADJUSTABLE FENCE

See Figure 6.

The adjustable fence is located at the rear of your cut-off

machine. As mentioned previously, it is used along with the

vise clamp to provide a clamp for holding your workpiece

securely when making cuts. It also makes your cut-off

machine more versatile.

The fence can be rotated to obtain cutting angles from 0° to

45°. It also can be moved back to allow greater cutting widths

in thin stock, or forward to allow greater cutting depths in tall

or thick stock.

CUTTING ANGLE ADJUSTMENT

See Figures 6 and 7.

■ Unplug your cut-off machine.

WARNING:

Failure to unplug cut-off machine could result in accidental

starting causing possible serious personal injury.

■ Using the 8 mm hex key supplied, loosen the two socket

head bolts securing adjustable fence.

See Figure 7.

■ Rotate fence until the desired angle of cut on the scale is

aligned with the indicator in machine base.

■ For precise cuts, check the angle of cut for the fence

against the abrasive wheel with a protractor, bevel square,

or other similar device.

■ Using the 8 mm hex key supplied, securely tighten socket

head bolts. Return hex key to its storage area in base.

■ This will secure the fence in place at desired angle.

See Figure 6.

ADJUSTING WIDTH OF CUT

See Figures 7 and 8.

■ Unplug your cut-off machine.

WARNING:

Failure to unplug cut-off machine could result in accidental

starting causing possible serious personal injury.

■ To increase the width of cut of your cut-off machine, use

the 8 mm hex key to loosen and remove the socket head

bolts and washers securing fence to machine base.

■ Reposition the curved slot of the fence with the threaded

hole in back of the machine base.

■ Install a socket head bolt through a lock washer and flat

washer into machine base. Do not tighten bolt securely.

■ Align remaining fence bolt hole with the middle threaded

hole in the machine base.

■ Install socket head bolt through lock washer and flat

washer into machine base.

■ Check and adjust fence to desired cutting angle.

Fig. 7

Fig. 8

ADJUSTABLE

FENCE

SCALE

INDICATOR

ADJUSTABLE

FENCE

SCALE

VISE

CLAMP

SOCKET HEAD

BOLTS

SOCKET HEAD

BOLTS

ADJUSTABLE

FENCE

THREADED

HOLE

1 ... 10 11 12 ... 20

Comments to this Manuals

No comments

Ryobi C358 User Manual Page 11

Comments to this Manuals

Related products and manuals for Power saws Ryobi C358