Ryobi RB100 Operator's Manual download pdf (Page 7)

Page 7

Fig. 1

FEATURES

ON/OFF

SWITCH

FOAM PAD

INSULATED HANDLES

CORD

KNOW YOUR BUFFER/POLISHER

See Figure 1.

Before attempting to use your new Ryobi buffer/polisher,

familiarize yourself with all the safety rules listed in this

Operator's Manual and the operating features shown below.

Cord

6-foot cord.

Insulated Handles

Insulated handles with fitted pistol grip.

Application Bonnet

Re-useable application bonnet made of 100% terrycloth.

Polishing Bonnet

Re-useable polishing bonnet is made of synthetic tufted

material.

Foam Pad

9-1/2 in. (241 mm) pad is 1-3/8 in. (35 mm) thick.

On/Off Switch

Thumb activated for easier operation.

Motor Housing

Always make sure air vents are unobstructed during use.

WARNING:

Do not allow familiarity with your buffer/polisher to make

you careless. Remember that a careless fraction of a

second is sufficient to inflict severe injury.

WARNING:

Your buffer/polisher has a precision built electric motor. It

should only be connected to a power supply that is

120 volts, 60 Hz, AC only (normal household current).

Do not operate this tool on direct current (DC). A substantial

voltage drop will cause a loss of power and the motor will

overheat. If your tool does not operate when plugged into

an outlet, double check the power supply.

MOTOR HOUSING

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Ryobi RB100 Operator's Manual Page 7