Ryobi TS230 Operator's Manual download pdf (Page 27)

Page 27

TROUBLESHOOTING

1. Plug in saw.

2. Have switch replaced by Ryobi

Factory or Authorized Service

Center.

3. Replace fuse or reset circuit

breaker.

4. Have cord replaced by Ryobi

Factory or Authorized Service

Center.

5. Replace brushes.

1. Replace blade.

2. Turn blade around.

3. Remove blade and clean with

turpentine and coarse steel wool.

4. Change the blade.

1. Replace with the adequate size

extension cord.

2. Contact the electric company.

1. Tighten blade screw.

2. Tighten all mounting hardware.

3. Reposition workbench on flat

surface. Fasten workbench to

floor if necessary.

4. Clean blade and blade flanges.

1. Replace blade.

2. Check and adjust positive stop.

3. Check and adjust table.

1. Position bowed material correctly

(convex side to the back fence).

1. Return to a RYOBI Factory or

Authorized Service Center for

adjustment.

2. Replace spring.

1. Saw not plugged in.

2. Faulty switch.

3. Fuse blown or circuit breaker

tripped.

4. Cord damaged.

5. Worn, broken brushes.

1. Dull blade.

2. Blade mounted backwards.

3. Gum or pitch on blade.

4. Incorrect blade for work being

done.

1. Extension cord too light or too

long.

2. Low supply voltage.

1. Blade screw not tight.

2. Saw not mounted securely to

workbench.

3. Workbench on uneven floor.

4. Blade or blade flanges not clean.

1. Damaged saw blade.

2. Positive stop not adjusted

correctly.

3. Blade is not perpendicular to

table.

1. Cutting bowed material in wrong

position.

1. No spring tension.

2. Spring broken.

PROBLEM CAUSE SOLUTION

Saw will not start.

Saw makes unsatisfactory cuts.

Blade does not come up to speed.

Saw vibrates excessively.

Does not make accurate 45° and

90° cuts.

Material pinches blade.

Saw blade does not return to UP

position.

1 2 ... 22 23 24 25 26 27 28

Comments to this Manuals

No comments