Ryobi P513 Operator's Manual download pdf (Page 9)

9 – English

OPERATION

WARNING:

Make sure blade does not touch work until motor reaches

full speed, since this could cause loss of control resulting

in serious injury.

With saw blade at full cutting speed, slowly tilt saw downward

until tip of blade starts cutting work. After blade penetrates

work, tilt saw until blade is perpendicular to the work.

METAL CUTTING

See Figure 7, page 11.

Metals such as sheet steel, pipe, steel rods, aluminum,

brass, and copper may be cut with the saw. Be careful not to

twist or bend the saw blade. Do not force. We recommend

cutting oil when cutting most soft metals and steel. Cutting

oil will also keep blades cool, increase cutting action, and

prolong blade life.

Never use gasoline since normal sparking of motor could

ignite fumes. Clamp the work firmly and cut close to the

clamping point to eliminate any vibration of the work being

cut. When cutting conduit pipe or angle iron, clamp work

in a vise if possible and cut close to the vise. To cut thin

sheet material, sandwich the material between hardboard

or plywood and clamp the layers to eliminate vibration and

material tearing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Ryobi P513 Operator's Manual Page 9