Ryobi YN100A Operator's Manual download pdf (Page 9)

9 — English

OPERATION

NOTE: When inflating items of 10 PSI, 0.69 BAR, 0.70 KG/

or less, inflate in short bursts and check after each

burst by feel or with a reliable measuring device to determine

accurate pressure.

Turn off the unit once inflation is complete.

INSTALLING NOZZLES

See Figure 7, page 11.

WARNING:

Improperly attached nozzles can become detached under

pressure and cause serious injury. Possible air leaks can

cause faulty pressure readings. Make sure all connections

are tightly secured.

The high pressure air hose can be used with inflation nozzles

to inflate a variety of items.

Position air chuck clamp in the unlock position

perpendicular to the high pressure air hose.

Insert nozzle into air chuck and push air chuck clamp

down until it locks into place.

To remove, lift air chuck clamp up and remove nozzle

from air chuck.

USING THE PRESSURE GAUGE

See Figure 8, page 11.

Pressure gauge accuracy is ±5 psi from 0-150 psi.

To use the pressure gauge:

 Place air chuck over valve stem and lock in place.

 NOTE: Do not turn the inflator on.

 Wait 5-7 seconds for an accurate pressure readout.

NOTE: The pressure readout on the gauge while inflating

is a measurement of the fluctuating pressure between the

item and the high pressure hose. To get an accurate read-

ing, stop inflating and follow above instructions for reading

the air pressure.

CAUTION:

Avoid over inflation. Always follow the maximum inflation

guidelines stated by the manufacturer of the item being

inflated.

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal injury.

REPLACING THE 12 V ADAPTOR FUSE

See Figure 9, page 11.

The 12 V adaptor contains a 250 V 8 Amp fuse to protect

the adaptor from unexpected power surges.

To replace the fuse:

 Remove the fuse cap from the top of the 12 V adaptor.

 Replace old fuse with new one. If spring comes out, be

sure to reinsert it before installing new fuse.

CAUTION:

Do not use a higher rated fuse than the specified amper-

age. This could cause damage to the product.

 Place fuse cap on top of fuse and thread back onto adap-

tor. Tighten securely.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 10 AFTER

FRENCH AND SPANISH LANGUAGE SECTIONS.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Ryobi YN100A Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Ryobi YN100A