Ryobi YN100A Operator's Manual download pdf (Page 8)

8 — English

OPERATION

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this inflator. The

use of attachments or accessories not recommended

can result in serious personal injury.

WARNING:

Do not leave items to be inflated unattended while in-

flator is in use. These items can burst and could cause

serious injury.

CAUTION:

The inflator is not designed for continuous use. For every

ten minutes of inflator use, ten minutes of cool down

time are required.

WARNING:

Since the pressure gauge is not calibrated, and is

therefore not binding for exact values, tire pressure

must be checked using a reliable measuring device

before driving a vehicle with tires inflated using the

inflator. Driving a vehicle with improperly inflated tires

could result in serious injury.

CAUTION:

The inflator is capable of inflating to 150 PSI, 10.34 BAR,

or 10.55 Kg/Cm

. To avoid over inflation, carefully follow

instructions on items to be inflated. To avoid product

damage, never exceed recommended pressures.

APPLICATIONS

You may use this inflator for the purpose listed below:

Inflating high pressure items like motorcycle, car, and

bicycle tires

NOTE: The inflator is not designed for commercial application.

POWERING THE INFLATOR

See Figure 2, page 10.

Turn inflator off and connect the unit to a 12 V DC power

supply using the 12 V adaptor.

NOTE: The inflator will not function unless connected to a

12 V DC power source.

NOTE: Powering the unit using a vehicle’s 12 V receptacle

when the engine is not running will drain the vehicle’s battery.

HIGH PRESSURE AIR HOSE

See Figure 3, page 10.

The high pressure air hose is used for inflating high pressure

items like motorcycle, car, and bicycle tires.

ACCESSORY COMPARTMENT

See Figure 4, page 10.

Inflator accessories can be stored in the accessory com-

partment located on the bottom of the inflator. To open the

accessory compartment, push down on the tab and remove

the flip-down door.

ON/OFF SWITCH

See Figure 5, page 11.

To turn the inflator ON (I), depress the on/off switch to the

on position. To turn it OFF (O), depress the switch to the off

position.

INFLATING WITH THE HIGH PRESSURE AIR

HOSE

See Figure 6, page 11.

The air chuck on the high pressure air hose can be used

without adaptors to inflate tires or with any application that

has a valve stem that fits the air chuck opening.

Turn the inflator off.

Position air chuck clamp in the unlock position

perpendicular to the high pressure air hose.

Place air chuck on valve stem.

Push air chuck down so that the threaded section of the

valve stem is inside the air chuck.

Clamp the end of the air chuck down onto the valve

stem by pressing air chuck clamp down until it stops or

is parallel with the high pressure air hose.

Turn on the inflator and inflate item to desired pressure.

To determine air pressure using the pressure gauge, refer

to instructions in the Using the Pressure Gauge section

later in the manual.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Ryobi YN100A Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Ryobi YN100A