Ryobi RB100 Operator's Manual download pdf (Page 9)

Page 9

WARNING:

Do not wear loose clothing or jewelry and contain long hair

when operating buffer/polisher. They could get caught in

moving parts, causing serious injury.

CHANGE TO BUFFING BONNET

Remove the application bonnet by loosening the drawstring

and slipping the bonnet off the pad. Replace with buffing

bonnet, attaching it the same way as the application bonnet.

WARNING:

The drawstring must be tucked securely inside the bonnet

before turning the buffer/polisher on. Failure to do so could

result in the drawstring being caught between the motor

housing and orbiting pad, increasing the risk of serious

injury.

Buff the surface in the same order: starting with large flat

surfaces and ending with hard-to-reach areas. Use the same

motion, a broad sweeping criss-cross pattern on large flat

areas and small circular motions on all other areas. Remember

to let the polisher do the work.

APPLY POLISH TO SURFACE

See Figure 5.

WARNING:

Always wear safety goggles or safety glasses with side

shields during operation.

While holding the polisher firmly against the surface, slide the

On/Off switch to the On position with your thumb. Always

start and stop the polisher on or against the surface

being polished.

Begin by polishing larger flat surfaces, such as hood, trunk

and roof. Use a broad sweeping motion in a criss-cross

pattern. Do not press down on the surface with the polisher,

let the orbital action of the pad and bonnet do the work.

Fig. 5

Once flat surfaces have been covered, polish curved surfaces

such as car doors and quarter panels. Use small circular

motions. Grip polisher with your hands at 3 and 9 o'clock so

that the cord hangs free.

After applying polish to the entire surface, turn polisher off by

pulling the On/Off switch toward you with your thumb. Wait

until the pad stops rotating before lifting the polisher from the

surface. Unplug polisher.

For hard to reach areas, such as the underside of bumpers or

side mirrors, apply polish by hand.

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Ryobi RB100 Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Power sanders Ryobi RB100