Ryobi RT501W Specifications download pdf (Page 16)

MOUNTING THE ROUTER

See Figure 16

6. Screw the three locating pins (Y) into nuts on adapter

plate from top side at hole position H.

Y (3)

Fig. 16

Fig. 17

See Figure17

7. Turn the router table upside-down. Align the three

locating pins in the bottom of the table top as shown.

Fig. 15

III. Mounting Routers with the universal

clamping system

Note: All routers will require using the adapter plate (F)

and locating pins (Y) when mounting the router to the

router table with the universal clamping system. Refer to

Hole Pattern Chart on page 14 to determine the correct

hole pattern for your router.

See Figure 15

1. Remove base plate from router.

2. Place the adapter base plate (F) on the router base

according to the mounting hole position chart on page

14.

3. Use screws removed from the router base plate to

attach the adapter base plate to the router base.

Tighten securely.

AM/AN (3)

WARNING:

Make sure screws from router base plate match the

countersinks in the adapter plate and are long enough

to attach the base plate securely. Replace if neces-

sary.

4. Routers with A and AB hole pattern use three counter-

sink 5/16" - 18 X 3/4" screws (AM), to attach the

adapter plate (F) to the router. For Ryobi routers RE600

and RE601 use three M 8 x 20 countersink screws

(AN).

5. To mount Craftsman routers that use the E-hole pat-

tern to the adapter plate (F), three 10 - 32 x 1/2" coun-

tersink screws are required (not provided).

AM or AN

NOTE: Countersink

screws

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Ryobi RT501W Specifications Page 16

Comments to this Manuals

Related products and manuals for Networking Ryobi RT501W