Ryobi TS1550 Operator's Manual download pdf (Page 22)

ADJUSTMENTS

Fig. 24

LOCK NUT

BEVEL

LOCK

KNOB

PIVOT POINTS

The following adjustments are made at the factory and

normally do not require readjustment.

TRAVEL PIVOT

The saw arm should rise completely to the up position by

itself. If the saw arm does not raise by itself or if there is

play in the pivot joints, have saw repaired by a qualified

service technician to avoid risk of personal injury.

BEVEL PIVOT

The compound miter saw should bevel easily by loosening

the bevel lock knob and tilting the saw arm to the left. If

movement is tight or if there is play in the pivot, have saw

repaired by a qualified service technician.

DEPTH STOP

The depth stop limits the blade's downward travel. It

allows the blade to go below the miter table enough to

maintain full cutting capacities. The depth stop positions

the blade 1/4 in. (6.4 mm) from the miter table support.

NOTE: The miter table support is located inside the miter

table.

The depth stop is factory set to provide maximum cutting

capacity for the 12 in. (305 mm) saw blade provided with

the saw. Therefore, the depth stop should not need an

adjustment for the saw blade provided.

WARNING:

If any part fails to function properly, do not operate

this tool until you have it repaired by a qualified

service technician. Failure to heed this warning can

result in serious personal injury.

1 2 ... 17 18 19 20 21 22 23 24 25 26

No comments

Ryobi TS1550 Operator's Manual Page 22