Ryobi TS1550 Operator's Manual download pdf (Page 20)

ADJUSTMENTS

SQUARING THE MITER TABLE TO THE

FENCE

See Figures 18 through 22.

Follow these directions to square the miter table to the

fence.

■ Unplug the saw.

WARNING:

Failure to unplug the tool could result in accidental

starting causing possible serious personal injury.

■ Push down on the saw arm.

■ Pull out the lock pin to release the saw arm.

■ Raise the saw arm to its full raised position.

■ Loosen the miter lock handle by rotating it approxi-

mately one-half turn.

■ Loosen the socket head screws securing the miter

lock lever.

■ Grasp the miter lock handle and rotate the miter

table until the miter pointer is positioned at 0°.

■ Tighten the miter lock handle securely.

■ Tighten the socket head screws to secure the miter

lock lever.

■ Lay a framing square flat on the miter table.

■ Place one leg of the square against the fence.

■ Place the other leg of the square beside the zero

clearance throat plate in the miter table.

NOTE: The edge of the square and the zero

clearance throat plate in the miter table should be

parallel. If the edge of the framing square and the

zero clearance throat plate in the miter table are not

parallel, adjustments are needed. Continue as follows.

■ Loosen the socket head screws securing the fence.

■ Adjust the fence until the framing square and zero

clearance throat plate are parallel.

■ Retighten the screws securely and recheck the fence-

to-table alignment.

Fig. 20

Fig. 18

PULL OUT

LOCK PIN

PUSH DOWN

ON ARM

Fig. 19

SOCKET

HEAD

SCREW

MITER LOCK

HANDLE

MITER

POINTER

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Ryobi TS1550 Operator's Manual Page 20

Comments to this Manuals

Related products and manuals for Mitre saws Ryobi TS1550