Ryobi AG700 User Manual download pdf (Page 18)

Surfaces that have an old film of wax or polish, or that have

not been polished or waxed for an extended period of time,

may require a second application. This is especially true

on oxidized surfaces. Heavily oxidized surfaces should be

cleaned with a commercial paste or liquid cleaner before

polishing or waxing.

WARNING:

Check polishing bonnets before each use. Make sure

they are clean and free from any loose particles or foreign

objects that may be embedded in the bonnet. Failure to

do so could cause these particles or objects to be thrown

from the tool resulting in possible serious injury.

OPERATION

POLISHING

See Figure 14.

WARNING:

Keep a firm grip on the tool with both hands at all times.

Failure to do so could result in loss of control leading to

possible serious injury.

When polishing, hold the tool firmly, allowing it to operate

freely without unnecessary pressure. The weight of the tool

alone will provide adequate pressure for polishing at top

efficiency. For best results, always operate at low speed

when polishing.

Bonnets must be kept clean and free from grit, dirt, and

other abrasive particles. When bonnets become dirty and

clogged with polishing film, wash in lukewarm water with

a mild detergent. Allow bonnets to dry thoroughly before

reuse. Polish with a long sweeping motion, back and forth,

advancing along the surface to be polished. Do not hold the

tool in one spot or use a circular or spiral pattern. This will

cause swirls in the finish.

Spread a light coat of polish or wax over a small area. Polish

with the tool according to the manufacturer’s instructions

printed on the label of the polish or wax container.

NOTE: Some polishes should be buffed while damp while

others must be allowed to dry; therefore, always check the

manufacturer’s label.

Tilt the tool so that the polishing bonnet is at a slight angle

to the work surface. Always start polishing at the top or

highest point and work down. This will prevent light dust or

polish film from being thrown upon completed section. It

also eliminates pulling the tool’s power cord over sections

already polished.

Fig. 14

1 2 ... 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Ryobi AG700 User Manual Page 18

Comments to this Manuals

Related products and manuals for Special machinery Ryobi AG700