Ryobi TSS100L1 User Manual download pdf (Page 18)

18 — English

ASSEMBLY

REMOVING / REPLACING THE THROAT PLATE

See Figure 17.

WARNING:

The throat plate must be below the saw table. If the throat

plate is too high or too low, the workpiece can catch on

the uneven edges resulting in binding which could result

in serious personal injury.

Never operate the saw without a throat plate installed.

To remove / replace:

 Unplug the saw.

 Remove the screws securing the right side of the zero

clearance throat plate.

 Lift the throat plate from the saw. Repeat the above steps

for the left side of the throat plate.

 To reinstall the throat plate, align the holes in the throat

plate with the holes in the saw base.

 Retighten the screws, being careful not to overtighten

which can cause the throat plate to bow or bend.

ADJUSTING SUPPORT FOOT

See Figure 17.

When making sliding cuts, turn the support foot clockwise

or counterclockwise depending on the amount of support

needed.

THROAT

PLATE

Fig. 17

SUPPORT

FOOT

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

No comments

Ryobi TSS100L1 User Manual Page 18