Ryobi HP61 Operator's Manual download pdf (Page 7)

Page 7

OPERATION

Fig. 3

WARNING:

If any parts are missing, do not operate tool until the

missing parts are replaced. Failure to do so could result

in possible serious personal injury.

SWITCH

See Figure 3.

Your drill starts and stops by depressing and releasing the

switch trigger.

Your drill has a two-speed feature in the switch. Depress

the switch trigger halfway for driving screws at low speed.

Depress the switch trigger all the way for normal drilling.

Release the switch trigger to turn drill OFF.

SWITCH LOCK

See Figure 3.

The switch trigger can be locked in the OFF position. This

feature helps reduce the possibility of accidental starting

when not in use. To lock the switch trigger, place the direction

of rotation selector in the center position.

DIRECTION

OF ROTATION

SELECTOR

SWITCH

TRIGGER

FORWARD

REVERSE

CENTER

POSITION (LOCK)

IMPORTANT INFORMATION FOR

RECHARGING HOT BATTERIES

When using your drill-driver continuously, the batteries be-

come hot. You should let the batteries cool down for approxi-

mately 30 minutes before attempting to recharge.

Note: This situation occurs when continuous use of your

drill-driver causes the batteries to become hot. It does not

occur under normal circumstances. Refer to "Charging

Your Drill-Driver" for normal recharging of batteries. If the

charger does not charge your batteries under normal circum-

stances, return both the drill-driver and charger to your

nearest AUTHORIZED SERVICE CENTER for electrical

check.

For more information on the battery recycling call

1-800-8 BATTERY.

CAUTION:

Your drill contains special high temperature batteries to

help prevent battery damage when left on charge for

extended periods of time. However, once the batteries

become fully charged, we recommend that you unplug

your charger from power supply and disconnect it from

drill.

REVERSIBLE

See Figure 3.

This tool is reversible. The direction of rotation is controlled

by a selector located above the switch trigger. With the drill

held in normal operating position, the direction of rotation

selector should be positioned to the left of the switch for

drilling. The drilling direction is reversed when the selector is

to the right of the switch. When the selector is in center

position, the switch trigger is locked.

CAUTION:

To prevent gear damage, always allow chuck to come to

a complete stop before changing the direction of rotation.

To stop, release switch trigger and allow the chuck to come

to a complete stop.

WARNING:

Battery tools are always in operating condition. Therefore,

switch should always be locked when not in use or when

carrying at your side.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Ryobi HP61 Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Power drills Ryobi HP61