Ryobi OP401 User Manual download pdf (Page 4)

4 — English

OPERATION

WARNING:

Do not allow familiarity with products to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

APPLICATIONS

You may use this tool for the following purpose:

Charging Ryobi 40 Volt lithium-ion batteries

CAUTION:

If at any point during the charging process none of the

LEDs are lit, remove the battery pack from the charger

to avoid damaging the product. DO NOT insert another

battery. Return the charger and battery to your nearest

service center for service or replacement.

NOTICE:

Charge in a well-ventilated area. Do not block charger

vents. Keep them clear to allow proper ventilation.

CHARGING

See Figure 1, page 7.

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge

them before first use. If the charger does not charge your

battery pack under normal circumstances, return both the

battery pack and charger to your nearest repair center for

electrical check.

Charge time is approximately 1-1/2 hours and is dependent

upon the type of battery pack.

Make sure the power supply is normal household voltage,

120 volts, AC only, 60 Hz.

 Connect the charger to a power supply.

 Attach the battery pack to the charger by aligning the

raised ribs on the battery pack with the grooves in the

charger, then slide the battery pack onto the charger.

 Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

 Latches should snap into place to ensure charger is

correctly connected.

 Do not place the charger in an area of extreme heat or

cold. It will work best at normal room temperature.

 The battery pack will become slightly warm to the

touch while charging. This is normal and does not

indicate a problem.

 After charging is complete, the green LED will remain on.

To remove the battery pack from the charger, depress

latches and pull up on the battery pack.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the battery pack may become

hot. A hot battery pack may be placed directly onto the charger

port but charging will not begin until the battery temperature

cools to within acceptable temperature range. When a hot

battery pack is placed on the charger, the red LED will begin

flashing and the green LED will be off. When the battery

pack cools, the charger will automatically begin charging.

CHARGING A COLD BATTERY PACK

A cold battery pack may be placed directly onto the charger

port but charging will not begin until the battery temperature

warms to within acceptable temperature range. When a cold

battery pack is placed on the charger, the red LED will begin

flashing and the green LED will be off. When the battery pack

cools the charger will automatically begin charging.

ASSEMBLY

WARNING:

Do not use this product if it is not completely assembled

or if any parts appear to be missing or damaged. Use of

a product that is not properly and completely assembled

or with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this product or create

accessories or attachments not recommended for use

with this product. Any such alteration or modification is

misuse and could result in a hazardous condition leading

to possible serious personal injury.

If any parts are damaged or missing, please call 1-800-860-4050 for assistance.

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Ryobi OP401 User Manual Page 4

Comments to this Manuals

Related products and manuals for Photo Accessories Ryobi OP401