Ryobi RP4300 User Manual download pdf

how to get started

CAUTION: This How To Get Started sheet is

not a substitute for reading the operator’s manual.

To reduce the risk of injury or property damage, user

must read and understand operator’s manual before

using this product.

Install battery pack in motion alarm.

Install button cell batteries in remote control.

Set personal security code.

Press and hold the # key while entering the default security code – 0000.

Release the # key.

Enter a new security code from 4 to 10 digits.

Press the # key to store the new code.

Position motion alarm.

Follow the procedures described in Testing the detection range in the

operator’s manual to determine the exact area covered by the motion alarm.

Arm the device:

Enter your personal security code, then press the ARM button. You have

approximately 30 seconds to choose between chime or alarm mode and leave

the area. See the operator’s manual for the difference between the chime and

alarm modes.

Use the remote control and press the ARM button. You have approximately 30

seconds to choose between chime or alarm mode and leave the area. See the

operator’s manual for the difference between the chime and alarm modes.

Disarm the device:

Enter your personal security code, then press the DISARM button.

Use remote control and press the DISARM button.

For detailed instructions on how to perform any of

the steps below, please see the operator’s manual.

987000-661

3-24-09 (REV:00)

1 2

how to get started CAUTION: This How To Get Started sheet is not a substitute for reading the operator’s manual. To reduce the risk of injury or prop

Page 2

PoUr dÉBUter L’UtILIsatIoN dU ProdUIt ATTENTION : Le présent feuillet intitulé « Pour débuter l’utilisation du produit » ne remplace en

No comments

Ryobi RP4300 User Manual