Ryobi BC30 RY30060B Operator's Manual

Your new trimmer has been engineered and manufactured to Ryobi’s high standard for dependability, ease of operation, and operator safety. Properly car

Page 10ATTACHING THE POWER HEAD TO THE ATTACHMENTSee Figure 2. WARNING: Never attach or adjust any attachment while power head is running. Failure to

Page 11ATTACHING THE FRONT HANDLE - CS30 AND SS30See Figure 4.1. Remove the front handle, bolt, flat washer, lock washer, and wing nut from the Owner

Page 12ATTACHING THE GRASS DEFLECTOR WARNING: The line cutting blade on the grass deflector is sharp. Avoid contact with the blade. Failure to

Page 13ATTACHING THE SHOULDER HARNESS - BC30See Figure 9.1. Connect the latch on the shoulder harness to the strap hanger.2. Adjust the strap to a c

Page 14ASSEMBLYCONVERTING FROM STRING TRIMMER TO BRUSHCUTTER - BC30To convert from the string trimmer to the brushcutter, remove the string head assem

Page 15FUELING AND REFUELING THE TRIMMERFUEL MIXTUREThis product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle oil. Pre

Page 16TO ADVANCE THE CUTTING LINEString advance is controlled by tapping the string head on grass while running engine at full throttle.1. Run engin

Page 17BLADE THRUSTExercise extreme caution when using the blade with this unit. Blade thrust is the reaction that may occur when the spinning blade c

Page 18OPERATIONSTARTING AND STOPPINGSee Figures 21 - 23.TO START A COLD ENGINE:DO NOT squeeze the throttle trigger until the engine starts and runs.n

Page 19 WARNING: Use only original manufacturer's replacement parts, accessories and attachments. Failure to do so can cause poor p

Page 2n Introduction ...

Page 20STRING REPLACEMENTSee Figures 26 - 28.Use only monofilament string. Use original manufacturer's replacement string for best performance.St

Page 21MAINTENANCECLEANING THE EXHAUST PORT AND MUFFLERNOTE: Depending on the type of fuel used, the type and amount of oil used, and/or your operati

Page 22 WARNING: A leaking fuel cap is a fire hazard and must be replaced immediately.The fuel cap contains a non-serviceable filter and a check val

Page 23PROBLEM POSSIBLE CAUSE SOLUTIONIF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CON

Page 24CALL1-800-860-4050For any questions about operating or maintaining your trimmer, or brushcuttercall the Ryobi Help Line !Your trimmer has bee

Page 25WARRANTYRYOBI TECHNOLOGIES INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMS NONROAD AND SMALL OFF-ROAD ENGINESThe U.S. Env

Page 26NOTES

Page 27WARRANTYEMISSIONS MAINTENANCE SCHEDULE AND WARRANTED PARTS LISTEmissions Parts Inspect Before

983000-4516-04RYOBI TECHNOLOGIES INC.1428 Pearman Dairy Road Anderson, SC 29625Post Office Box 1207 Anderson, SC 29622Phone 1-800-8

Page 3GENERAL SAFETY RULES WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric sho

Page 4SPECIFIC SAFETY RULESSPECIFIC SAFETY RULES FOR TRIMMER USEn Replace string head if cracked, chipped, or damaged in any way. Be sure the string

Page 5Some of the following symbols may be used on this tool. Please study them and learn their meaning for safe operation of this product.

Page 6SYMBOLSThe following signal words and meanings are intended to explain the levels of risk associated with this product.SYMBOL SIGNAL

Page 7UNPACKINGSPECIFICATIONSWeight - (without fuel) CS30 (RY30020, RY30023)...

Page 8FEATURESFig. 1aTHROTTLE TRIGGERSTARTER GRIP AND ROPE FRONT HANDLECOUPLERDRIVE SHAFT HOUSINGSTRING HEADCURVED SHAFT GRASS DEFLECTORPRIMER BULBKNO

Page 9FEATURESFig. 1bFig. 1cTHROTTLE TRIGGER FRONT HANDLECOUPLERDRIVE SHAFT HOUSINGSTRING HEADSTRAIGHT SHAFT GRASS DEFLECTORTHROTTLE TRIGGER“J” BARRIE