Ryobi P712 Operator's Manual download pdf (Page 6)

6 — English

MAINTENANCE

This product contains no serviceable parts.

WARNING:

Always wear safety goggles or safety glasses with side

shields during product operation or when blowing dust.

If operation is dusty, also wear a dust mask.

WARNING:

To avoid serious personal injury, always remove the

battery pack from the product when cleaning or

performing any maintenance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal

injury.

BATTERY PACK REMOVAL AND PREPARATION

FOR RECYCLING

WARNING:

Upon removal, cover the battery pack’s terminals with

heavy-duty adhesive tape. Do not attempt to destroy

or disassemble battery pack or remove any of its

components. Batteries must be recycled or disposed

of properly. Also, never touch both terminals with metal

objects and/or body parts as short circuit may result.

Keep away from children. Failure to comply with these

warnings could result in fire and/or serious injury.

CLEANING THE HAND VAC

The dust bowl should be checked, emptied, and cleaned

periodically for maximum dust collection.

REMOVING THE DUST BOWL

See Figure 6, page 7.

Remove the battery pack from the vacuum.

Depress the release button located on top of the hand vac.

Pull the dust bowl down and out as shown to separate it

from the motor housing.

REMOVING AND CLEANING/REPLACING

THE FILTER

See Figure 7, page 7.

Remove the battery pack from the vacuum.

Remove the filter by pressing the tabs inward and lifting

the filter out of the screen assembly.

Shake or lightly brush any dust or dirt off the filter.

Shake or lightly brush any dust off the screen and screen

assembly. Wash if necessary.

Empty the dust bowl; wash if necessary. Before reattach-

ing to the hand vac, make sure all pieces are completely

dry.

When purchasing replacement filter, request recommended

part number 019484001007.

REATTACHING THE DUST BOWL

See Figure 8, page 7.

Position the two sections as shown. Align the slot on the

bottom of dust bowl with the tab on the bottom of motor

housing, then snap the two sections together.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 7 AFTER

FRENCH AND SPANISH LANGUAGE SECTIONS

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Ryobi P712 Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Battery chargers Ryobi P712