Ryobi ES5500 Use and Care Manual download pdf (Page 5)

5 - English

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts could create a hazard or cause

product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

STORAGE

Store in a cool, dry location to prevent condensation or mold

from forming inside the product.

Do not store the device at temperatures greater than 122º

F (such as on a dashboard or vehicle interior).

BATTERY RECYCLING

Consult the Earth 911 website (www.earth911.com) or your

local waste authority for information regarding available

recycling and/or disposal options.

WARNING:

Do not attempt to destroy or disassemble batteries or

remove any of their components. All batteries must be

recycled or disposed of properly. Do not discard large

amounts of used batteries together. “Dead” batteries

often have residual charge. When grouped together, these

batteries can become “live” and pose a risk of possible

serious injury.

Locating studs or joists:

 Once calibration is complete, begin to slowly move the

unit in a straight line to the left or right against the wall.

 As you near a stud, the graduated display will begin to

light up. When you reach the center of the stud, the dis-

play will fully light up and the word STUD CENTER will

appear at the top.

 To mark where center is, depress the button at the bottom

of the unit to make a mark on the wall at the point where

STUD CENTER appeared on the display. This will leave

a small dimple on the wall surface.

OPERATION

Fig. 4

“No Stud”

Indicator

Calibrating

“Stud Center”

Indicator

Fig. 5

1 2 3 4 5 6

Comments to this Manuals

No comments

Ryobi ES5500 Use and Care Manual Page 5

Comments to this Manuals

Related products and manuals for Unknown Ryobi ES5500