Ryobi ZRCSB134L Use and Care Manual download pdf (Page 9)

9 - English

 Retract the lower blade guard into the upper blade guard

using the lower blade guard handle. Make sure the lower

guard spring works properly, allowing the guard to move

freely.

 Check to see that the saw teeth and arrow on the saw

blade and the arrow on the upper guard are pointing in

the same direction.

NOTE: The saw teeth point upward at the front of the saw

as shown.

 Fit the saw blade inside the lower blade guard and onto

the spindle.

WARNING:

If inner flange bushing has been removed, replace it

before placing blade on spindle. Failure to do so will

prevent blade from tightening properly and could result

in serious personal injury.

 Replace outer blade washer (“D” washer).

 Replace spring washer with cupped side against “D”

washer.

 Depress spindle lock and replace blade screw.

 Tighten blade screw securely by turning it clockwise with

the blade wrench.

NOTE: Never use a blade that is too thick to allow the

outer blade washer (“D” washer) to engage with the flat

on the spindle.

To remove the blade:

Unplug the saw.

Depress and hold spindle lock.

Remove blade screw by turning it counterclockwise

with the blade wrench, while keeping the spindle lock

depressed.

Remove spring washer and then remove outer blade

washer (“D” washer).

Lift lower blade guard.

Remove blade.

WARNING:

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental

starting and possible serious personal injury.

WARNING:

A 7-1/4 in. blade is the maximum blade capacity of the

saw. Also, never use a blade that is too thick to allow

outer blade washer to engage with the flat on the spindle.

Larger blades will come in contact with the blade guards,

while thicker blades will prevent blade screw from se-

curing blade on spindle. Either of these situations could

result in a serious accident.

NOTICE:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

INSTALLING/REMOVING BLADE

See Figures 2 - 4, page 17.

To install the blade:

 Unplug the saw.

 Depress and hold spindle lock.

 Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

 Remove spring washer and outer blade washer

(“D” washer).

 Wipe a drop of oil onto the inner flange bushing and outer

blade washer (“D”) where they contact blade.

ASSEMBLY

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may

contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive

harm. Wash hands after handling.

Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products and,

• arsenic and chromium from chemically treated lumber.

Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your

exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially

designed to filter out microscopic particles.

CALIFORNIA PROPOSITION 65

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comments to this Manuals

No comments

Ryobi ZRCSB134L Use and Care Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Ryobi ZRCSB134L