Ryobi HPL51 Operator's Manual download pdf (Page 14)

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear safety goggles or safety glasses with side

shields during power tool operation or when blowing

dust. If operation is dusty, also wear a dust mask.

WARNING:

Failure to unplug the planer could result in accidental

starting causing serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal

injury.

Electric tools used on fiberglass material, wallboard, spackling

compounds, or plaster are subject to accelerated wear and

possible premature failure because the fiberglass chips and

grindings are highly abrasive to bearings, brushes, commuta

tors, etc. Consequently, we do not recommended using this

tool for extended work on these types of materials. However,

if you do work with any of these materials, it is extremely

important to clean the tool using compressed air.

MAINTENANCE

Fig. 12

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit under

normal operating conditions. Therefore, no further lubrica-

tion is required.

CLEANING THE EXHAUST PORT AND

EMPTYING THE DUST BAG

See Figure 12.

After using the planer for an extended period of time or

when planing wet or green lumber, chips may build-up in the

exhaust port and require cleaning. Chip build-up restricts air

flow and causes the motor to overheat. Clean the exhaust

port and empty the dust bag regularly.

 Unplug the planer.

 Remove the dust bag from the exhaust port.

 Clean the chip or dust build-up from the exhaust port of

the planer with a small piece of wood. Do not use your

hands or fingers.

 Empty all debris from the dust bag and ensure that the

collar is free of debris.

 Replace the dust bag.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Ryobi HPL51 Operator's Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools Ryobi HPL51