Ryobi TS1354DXL User Manual download pdf (Page 14)

ASSEMBLY

TRACE HOLES

AT THESE LOCATIONS

FOR HOLE PATTERN

WARNING:

Do not start the compound miter saw without checking for

interference between the blade and the miter fence. Damage

could result to the blade if it strikes the miter fence during

operation of the saw.

WARNING:

This saw can tip over if the saw head is released suddenly

and the saw is not secured to a work surface. ALWAYS

secure this saw to a stable work surface before any use to

avoid serious personal injury.

MOUNTING HOLES

See Figure 7.

WARNING:

Always make sure the compound miter saw is securely

mounted to a workbench or an approved workstand.

Failure to heed this warning can result in serious

personal injury.

The compound miter saw should be mounted to a firm

supporting surface such as a workbench. Four bolt holes

have been provided in the saw base for this purpose. Each

of the four mounting holes should be bolted securely using

3/8 in. machine bolts, lock washers, and hex nuts (not

included). Bolts should be of sufficient length to accommodate

the saw base, lock washers, hex nuts, and the thickness of the

workbench. Tighten all four bolts securely.

The hole pattern for mounting to a workbench is shown in fig

ure 7. Carefully check the workbench after mounting to make

sure that no movement can occur during use. If any tipping,

sliding, or walking is noted, secure the workbench to the floor

before operating.

Fig. 7

MOUNTING SURFACE

SAW BASE

TRACE HOLES

AT THESE LOCATIONS

FOR HOLE PATTERN

UNPACKING

This product requires assembly.

 Carefully lift saw from the carton by the carrying handle and

the saw base, and place it on a level work surface.

NOTE: This tool is heavy. To avoid back injury, lift with your

legs, not your back, and get help when needed.

 This saw has been shipped with the saw arm secured in the

down position. To release the saw arm, push down on the top

of the saw arm, cut the tie-wrap, and pull out on the lock pin.

 Lift the saw arm by the handle. Hand pressure should

remain on the saw arm to prevent sudden rise upon

release of the tie wrap.

 Inspect the tool carefully to make sure no breakage or dam-

age occurred during shipping.

 Do not discard the packing material until you have carefully

inspected and satisfactorily operated the tool.

 The saw is factory set for accurate cutting. After

assembling it, check for accuracy. If shipping has

influenced the settings, refer to specific procedures

explained in this manual.

 If any parts are damaged or missing, please call

1-800-525-2579 for assistance.

WARNING:

If any parts are missing, do not operate this tool until the

missing parts are replaced. Failure to do so could result in

possible serious personal injury.

WARNING:

Do not attempt to modify this tool or create accessories not

recommended for use with this tool. Any such alteration

or modification is misuse and could result in a hazardous

condition leading to possible serious personal injury.

WARNING:

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental start

ing and possible serious personal injury.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comments to this Manuals

No comments

Ryobi TS1354DXL User Manual Page 14

Comments to this Manuals

Related products and manuals for Power saws Ryobi TS1354DXL