Ryobi RTS30 User Manual download pdf (Page 15)

ASSEMBLY

UNPACKING

This product requires assembly.

 Carefully lift saw from the carton and place it on a level

work surface.

NOTE: This tool is heavy. To avoid back injury, keep your

knees bent and lift with your legs, not your back, and get

help when needed.

WARNING:

Do not use this product if any parts on the Loose Parts List

are already assembled to your product when you unpack

it. Parts on this list are not assembled to the product by

the manufacturer and require customer installation. Use

of a product that may have been improperly assembled

could result in serious personal injury.

 Inspect the tool carefully to make sure no breakage or

damage occurred during shipping.

 Do not discard the packing material until you have

carefully inspected the tool, identified all loose parts, and

satisfactorily operated the tool.

NOTE: Remove the foam block from between the saw’s

housing and the motor by first beveling the blade (see

page 25).

 The saw is factory set for accurate cutting. After

assembling it, check for accuracy. If shipping has

influenced the settings, refer to specific procedures

explained in this manual.

 If any parts are damaged or missing, please call

1-800-525-2579 for assistance.

WARNING:

If any parts are damaged or missing, do not operate

this tool until the parts are replaced. Use of this product

with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this tool or create accesso-

ries not recommended for use with this tool. Any such

alteration or modification is misuse and could result in a

hazardous condition leading to possible serious personal

injury.

WARNING:

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental

starting and possible serious personal injury.

WARNING:

Do not lift the saw without help. Hold it close to your body.

Keep your knees bent and lift with your legs, not your

back. Ignoring these precautions can result in back injury.

WARNING:

Never stand directly in line with the blade or allow hands

to come closer than 3 in. to the blade. Do not reach over

or across the blade. Failure to heed this warning can

result in serious personal injury.

WARNING:

To avoid serious personal injury, always make sure the

table saw is securely mounted to a workbench or an ap-

proved leg stand. NEVER operate the saw on the floor.

MOUNTING HOLES

This tool comes mounted to a leg stand. If you chose to

remove the leg stand, the table saw must be mounted to

a firm supporting surface such as a workbench. Four bolt

holes have been provided in the saw’s base for this purpose.

Each of the four mounting holes should be bolted securely

using 3/8 in. machine bolts, lock washers, and hex nuts

(not included). Bolts should be of sufficient length to ac-

commodate the saw base, lock washers, hex nuts, and the

thickness of the workbench. Tighten all four bolts securely.

Carefully check the workbench after mounting to make

sure that no movement can occur during use. If any tipping,

sliding, or walking is noted, secure the workbench to the

floor before operating.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Comments to this Manuals

No comments

Ryobi RTS30 User Manual Page 15

Comments to this Manuals

Related products and manuals for Power saws Ryobi RTS30