Ryobi BS1001SV User Manual download pdf (Page 15)

Page 15

ASSEMBLY

TO SQUARE THE SAW TABLE TO THE BLADE

See Figure 11.

n Turn the blade guide lock knob counterclockwise to

unlock the blade guide assembly. Turning the blade guide

knob clockwise, raise the blade guide assembly as far as

it will go. Turn the lock knob clockwise to retighten.

n Place a small combination square on the saw table beside

the blade.

n Loosen the bevel lock knob and rotate the bevel

adjustment knob to tilt the saw table up or down to align

table 90° to blade (0° position). Retighten the bevel lock

knob.

n Using a hex key, adjust the zero stop set screw until the

set screw just touches the saw housing.

n Check squareness of the saw table to the blade. Make

readjustments if necessary.

n Loosen screw on scale indicator with a phillips screwdriver

and align scale indicator to zero.

n Tighten all screws securely.

TO INSTALL DUST BAG

See Figure 12.

This tool comes with a dust bag for dustless cutting. To

install the dust bag:

n Position the nozzle of the dust bag in line with the dust

exhaust port on the back of the band saw.

n Push the dust bag nozzle firmly into the exhaust port.

NOTE: For more efficient operation, empty dust bag when

no more than half full. Turn bag inside-out and shake

vigorously to remove dust. This will permit better air flow

through the bag.

BLADE

GUARD

SMALL

COMBINATION

SQUARE

SAW

BLADE

ZERO STOP

SET SCREW

DUST

BAG

DUST

EXHAUST

PORT

Fig. 11

Fig. 12

Fig. 10

WING

NUT

LOCK KNOB

WASHER

TABLE

ALIGNING

BOLT

BLADE GUIDE

KNOB

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments

Ryobi BS1001SV User Manual Page 15

Comments to this Manuals

Related products and manuals for Power saws Ryobi BS1001SV