Ryobi P232 Operator's Manual download pdf (Page 8)

8 — English

OPERATION

BUILT-IN COUPLER

See Figure 4, page 10.

The tool has a built-in coupler. The coupler has been de-

signed to accept 1/4 in. hex bits.

INSTALLING BITS

See Figure 4, page 10.

 Lock switch trigger on the tool by placing the direction

of rotation selector in center position.

 Slide the coupler forward and hold in position.

 Insert bit straight into coupler.

 Slide the coupler back slowly and release.

REMOVING BITS

See Figure 4, page 10.

 Lock switch trigger or the drill by placing the direction of

rotation selector in center position.

 Slide the coupler forward and hold in position.

 Pull bit straight out of coupler.

WARNING:

Make sure the bit is secured in the coupler before using

the impact driver. Failure to do so could cause serious

personal injury.

WARNING:

Do not drive a screw where there is likely to be hidden

wiring behind the surface. Contact with a “live” wire will

make exposed metal parts of the tool “live” and shock

the operator. If you must drive a screw where hidden wire

may be present, always hold tool by insulated gripping

surfaces (handle) when performing the operation to

prevent a shock to the operator, as seen in figure 5.

CAUTION:

The impact driver is not designed to be used as a drill.

DRIVING OR REMOVING SCREWS

See Figures 5 - 6, page 10.

 Place the direction of rotation selector in the correct

position for the operation.

 Hold the impact driver with one hand.

 Place the bit on the screw head and slowly depress the

switch trigger. Start the bit slowly for more control.

 As the screw is driven, impacting will begin.

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may

contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive

harm. Wash hands after handling.

Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products and,

• arsenic and chromium from chemically treated lumber.

Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your

exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially

designed to filter out microscopic particles.

CALIFORNIA PROPOSITION 65

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Ryobi P232 Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Power impact wrenches Ryobi P232