Ryobi P360 Use and Care Manual download pdf (Page 8)

8 — English

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second

is sufficient to inflict serious injury.

WARNING:

Always remove battery pack from the tool when you are

assembling parts, making adjustments, cleaning, or when

not in use. Removing battery pack will prevent accidental

starting that could cause serious personal injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Failure to do so could result in objects being thrown into

your eyes and other possible serious injuries.

APPLICATIONS

You may use this tool for the purposes listed below:

Finish and Trim (Interior and exterior)

Door & Window Casing

Door Jambs

Baseboard

Crown Molding

Cabinetry

Cap and Shoe Molding

Molding

Staircases

Door and Window Trim

Chair Rail

Brickmold

Hardwood Flooring

Paneling

Furniture

ATTACH BELT HOOK

See Figure 1, page 12.

The belt hook can be installed on the left or right side of the

stapler, depending on operator preference.

 Alignbelthookandscrewwithrightorleftsidescrew

hole.

 Usinga phillips screwdriver (notincluded) tighten se-

curely.

OPERATION

INSTALLING/REMOVING BATTERY PACK

See Figure 2, page 12.

 To install, place the battery pack in the tool. Align the

raised rib inside the tool with the groove on the battery

pack.

 Make sure the latches on each side of the battery pack

snap into place and battery pack is secured in tool before

beginning operation.

NOTE: Squeeze LED light grip switch to activate stapler.

To remove battery pack:

 To remove, locate latches on battery pack and depress

to release battery pack from the tool.

For complete charging instructions, see the operator’s

manuals for your battery pack and charger.

NO-MAR PAD

See Figure 3, page 12.

The no-mar pad attached to the nose of the tool helps pre-

vent marring and denting when working with softer woods.

To remove or replace the pad:

 Remove the battery pack.

 Remove the pad by pulling it down and away from the

nose.

 To replace the pad, fit it into place over the nose and

push up to reseat.

On-board storage for the pad is located on the magazine of

the tool. An extra no-mar pad is provided in the on-board

storage area.

LOADING THE TOOL WITH STAPLES

See Figures 4 - 5, pages 12 - 13.

WARNING:

Use only the staples recommended for use with this tool.

The use of any other staples can result in tool malfunction,

leading to serious injuries.

WARNING:

Keep the tool pointed away from yourself and others

when loading fasteners. Failure to do so could result in

possible serious personal injury.

 Remove battery pack from the tool, if installed.

 Hold the tool upside down with the nose pointed upward

and tilted away from you.

 Squeeze the magazine release button located at the rear

of the magazine and slide the magazine cover open.

 Place staples in the channel with the staple tips point-

ing upward and the crown resting on the bottom of the

channel.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Ryobi P360 Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Nail Gun Ryobi P360