Ryobi RY09605 Operator's Manual download pdf (Page 12)

10 — English

OPERATION

FOR MANUAL START:

To start a cold engine:

DO NOT engage the throttle until the engine starts and

runs.

Lay the product on a flat, bare surface.

PRIME - Press the primer bulb 7 times.

SET the start lever to the START position.

PULL the starter grip and rope until the engine starts.

Push the throttle to run.

NOTE: Engaging and releasing the throttle releases the start

lever to the RUN position.

To start a warm engine:

NOTE: Either of these options should be performed at full

throttle.

PULL the starter grip and rope until the engine starts.

When the operator is wearing the blower, the engine may

be started by depressing the START/STOP switch to the

START position.

To stop the engine:

DEPRESS and hold START/STOP switch in the STOP

position “

” until the engine stops.

IF ASSISTANCE IS REQUIRED STARTING THIS

PRODUCT:

Do not return this product to the retail store where it was

purchased. Please call our Customer Service Department

for any issues you may have.

For Help Call: 1-800-860-4050.

WARNING:

Keep away from all hot surfaces of the blower. Failure to

do so could result in possible serious personal injury.

OPERATING THE BLOWER

See Figure 12.

 Slip arm through harness strap and onto shoulder, then

repeat for the other shoulder. Adjust the straps to a

comfortable position. Refer to Adjusting Harness Straps

earlier in this manual. Remove unit for starting.

 Start the blower. Refer to Starting and Stopping earlier

in this manual.

 Put on the blower again. The unit should be operated on

the operator’s right side as shown.

 To keep from scattering debris, blow around the outer

edges of a debris pile. Never blow directly into the center

of a pile.

 Operate power equipment at reasonable hours only —

not early in the morning or late at night when people

might be disturbed. Comply with the times listed in local

ordinances.

 To reduce sound levels, limit the number of pieces of

equipment used at any one time.

 Operate blower at the lowest possible throttle speed to

do the job.

 Check your equipment before operation, especially the

muffler, air intakes, and air filters.

 Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water

is available.

 Conserve water by using power blowers instead of hoses

for many lawn and garden applications, including areas

such as gutters, screens, patios, grills, porches, and

gardens.

 Watch out for children, pets, open windows, or freshly

washed cars, and blow debris safely away.

 Use the wide sweeper nozzle for larger volume, so the

air stream can work close to the ground.

 After using blowers or other equipment, CLEAN UP!

Dispose of debris properly.

CAUTION:

Do not place blower on top of or near loose debris.

Debris may be sucked into blower intake vent resulting

in possible damage to the unit.

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Failure to do so could result in objects being thrown into

your eyes and other possible serious injuries.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Comments to this Manuals

No comments

Ryobi RY09605 Operator's Manual Page 12

Comments to this Manuals

Related products and manuals for Garden tools Ryobi RY09605